It is important that you read this manual thoroughly and fully understand the installation and operating procedures. Failure to follow instructions may result in property damage, bodily injury or even death. The more you understand the way your Regency Insert
operates, the more enjoyment you will experience from knowing that your unit is operating at peak performance.
Installation Instructions
Requirements for Installing
Solid-fuel Inserts in Factory-built Fireplaces.
1) The insert must be tested and meet the requirements of UL 1482 (U.S.) and or ULC S628 (Canada) when tested in a masonry fireplace built per ULC S628.
2) The factory-built fireplace must be listed per UL 127 or ULC S610.
3) Clearances obtained from the masonry fireplace tests are also relevant for installation in factory built fireplaces.
4) Installation must include a full height listed chimney liner type HT requirements (2100 degree F.) per UL 1777 (U.S.) or ULC S635 (Canada). The liner must be securely attached to the insert flue collar and the chimney top.
5) Means must be provided to prevent room air passage to the chimney cavity of the fireplace. This may be accomplished by sealing the damper area around the chimney liner, or sealing the fireplace front.
6) Alteration of the fireplace in any manner is not permitted with the following exceptions; a. external trim pieces which do not affect the operation of the fireplace may be removed providing they can be stored on or within the fireplace for re-assembly if the insert is removed. b. the chimney damper may be removed to install the chimney liner.
7) Circulating air chambers (i.e. in a steel fireplace liner or metal heat circulator) shall not be blocked.
8) Means must be provided for removal of the insert to clean the chimney flue.
9) Inserts that project in front of the fireplace must be supplied with appropriate supporting means.
10) Installer must mechanically attach the supplied label to the inside of the firebox of the fireplace into which the insert is installed.